Air-ConditioninG | Heating | Ductwork

Check inside Cooling Coil, if accessible: Build-up on the coil reduces the system’s ability to cool, making your air conditioning run longer, increasing energy consumption and raising your cooling costs.

​

Inspect Primary and Secondary Drains: A clogged condensate drain increases humidity levels and can cause ceiling damage.

​

Check and Clean Condenser: Foreign material on the condenser reduces the system’s cooling capacity. A dirty coil will increase your cooling cost by 50% or more, and can shorten the life of your air conditioner.

​

Check Operation Pressures for Proper Refrigerant Charge: Improper refrigerant charges – too much or too little – can damage the compressor and will cause high electric bills, and reduced cooling capacity due to efficient equipment operation.

​

Adjust Blower Components: Proper adjustment of blower and components is necessary for adequate airflow to assure maximum cooling performance.

​

Monitor AC Cycle: Our trained Technician will assure that the air conditioner is cycling properly.

​

Monitor Voltage & Amp. Draw on all Motors: Motors are designed to operate at standard voltage and amperage draw. By measuring amperage draw, problems can be identified before the unit fails.

​

Check and tighten all Loose Electrical Connections: Loose electrical connections are a common source of problems which cause your electric parts to fail and your air conditioner to become inoperative.

​

Clean and adjust Thermostat: To ensure even temperature control for your environment.

Adjust Blower Components: Proper adjustment of blower components is necessary for adequate airflow to ensure your furnace can deliver maximum heating capacity and efficiency.

​

Check & Test Safety Controls: Safety controls are essential for proper protection of the unit and your home.

​

Monitor Furnace Cycle: We will assure that the system is cycling properly, and that controls are calibrated correctly.

​

Inspect Gas Pressure: Proper gas pressure will ensure the most efficient and safe burner operation and reduces energy costs.

​

Check for Cracked Heat Exchanger: As furnaces age, cracks can develop in the heat exchanger, which can allow dangerous gases (including carbon monoxide) to enter your home and endanger your safety. We will thoroughly inspect accessible components of your heating system to determine if this hazard is evident.

​

Monitor Flue Draft for Safe Operation: An obstructed flue will cause products of combustion to enter your home.

​

Adjust Heat Anticipator Settings: The heat anticipator in your thermostat determines how often your furnace cycles and will affect the cost of operation, as well as the comfort level.

​

Check & Adjust Ignition Operation: A properly adjusted ignition assures that your furnace will start reliably all winter.

​

Adjust Air Flow for proper Temperature Use: Properly adjusted blower speed will ensure efficient and reliable furnace operation and comfort.

 

Check and tighten all Loose Electrical Connections: Loose electrical connections are a cause of equipment failure.

​

Monitor Voltage & Amp. Draw on all Motors: Motors are designed to operate at standard voltage and amperage draw. By measuring amperage draw, problems can be identified before the unit fails.

​

Clean & Adjust Thermostat: To ensure even temperature control throughout your home.